Barco R9001390 - Manual (Page 41)

9-1
Installation Mode
5975938 BARCOREALITY 9200TCR+ 020798
9
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
INSTALLATION MODE
Starting up the Installation Mode
Push the control disc up or down to highlight Installation and then
press ENTER.
ENTER continues to the Installation mode selection menu.
EXIT returns to operational mode.
The following item can be selected in the Installation mode :
Input slots : to set up the input priority.
800 Peripheral : to select the type of output module used in the
RCVDS05.
Convergence : to align the red, green and blue image.
Configuration : to set up the projector position.
OSD color : to change the color of the highlighted item.
No Signal : to display a black or blue screen when no source is
connected to the projector.
Internal Patterns
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
CONVERGENCE
CONFIGURATION
OSD COLOR
NO SIGNAL [BLACK]
INTERNAL PATTERNS
Select with or
then <ENTER>
<EXIT> to return.
Input Slots
Highlight Input Slots by pushing the control disc up or down and press
ENTER.
The internal system will scan the input slots and displays the result
in the Input Slots menu.
Source indication
Video or S-Video Video[Video]
Video[S-Video]
RGB analog RGB-SS[CV] : separate sync is composite video
signal on H/C input
RGB-SS[CS or HS&VS] : separate sync is
composite sync or horizontal and vertical
sync
RGB-SOG : sync on green
Component video Component Video - SS : component video
with separate sync
Component Video - SOY : component video
with sync on Y
Component Video - 3LSS : component video
with 3 level separate sync.
Component Video - 3LSOY : component
video with 3 level sync on Y.
RGB analog with
tri-level sync
RGB3L-SS : RGB with separate Tri level sync
RGB3L-SOG : RGB with Tri level sync on
green
For slot 1 and slot 2, see chapter 'Connections'
If a RCVDS (switched on) or VS05 is connected to the projector, it will
be also indicated on the menu by adding
+800 peripheral . If no 800
peripheral indication is made on the menu, there are still two possi-
bilities :
- no RCVDS or VS05 connected or
- RCVDS is switched off.
When a 800 peripheral is connected to the projector, the input slots
are not accessible with the control disc to toggle their function.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
CONVERGENCE
CONFIGURATION
OSD COLOR
NO SIGNAL [BLACK]
INTERNAL PATTERNS
INPUT SLOTS
1. RGB-SS [CV]
2. RGB-SOG
3. Video [Video]
4. Component Video