BT MANGO - Manual (Page 80)

Help
Phone does not work
• Have you installed the batteries correctly? See page 87.
• Check that the mains power is correctly connected.
No dial tone
• Is the telephone cord of the base plugged into the phone socket?
• Check that the mains power is correctly connected.
• Only use the telephone cord supplied with the phone.
Cannot dial out or receive calls
• Check that the mains power is correctly connected.
• The batteries may need recharging.
• Has there been a power cut? If so, place the handset back on the base for 10 seconds
and try again. If it still does not work disconnect the batteries and mains power for 10
minutes, then reconnect and try again.
You have a dial tone, but the phone will not dial out
• You may need to change the dial mode from tone to pulse, see page 35.
• If you are connected to a switchboard, check whether you need to dial an access code.
Handset does not ring
• The ringer volume may be switched off, see page 29.
• Check that the mains power is correctly connected.
• Make sure the handset is registered to the base, see page 75.
No display
• The batteries may be flat, dead or incorrectly inserted.
• Recharge or replace the batteries.
80
Mango – Issue 2 – Edition 2 – 28.06.06 – 7677
If you experience any problems, please call the Helpline on 0870 605 8047 or email [email protected]