Heidolph SilentCrusher M - Manual (Page 33)

- 33 -
E
E
GENERAL INFORMATION
Please unpack the device carefully.
Check for any damage and report damage or missing parts to the supplier immediately.
Read the operating instructions thoroughly and attentively and ensure that every opera-
tor of the device has read the operating instructions carefully before start-up.
Please keep the operating instructions in a location accessible to everyone.
The device is equipped with a EUROPEAN plug in accordance with the standards
(DIN 49441 EEC 7/VII 10/ 16 A 250 V).
For North America with a US STANDARD plug (NEMA Pub. No. WDI.1961 ASA C 73.1.
1961 page 8 15A 125V).
If you want to use the device in a country with a different outlet system, you must use an
adapter or have the plug supplied with the equipment replaced by a technician with an
approved plug suited for this power supply system.
The device is grounded when delivered. If the original plug is changed, you must make
absolutely sure that the protective ground wire is connected to the new plug.
SAFETY INSTRUCTIONS
Please follow all safety and accident prevention regulations in effect in the
laboratory.
Before plugging the device into the power supply circuit, ensure that the mains voltage
matches the data on the rating plate.
Repairs may be made only by a Heidolph Instruments authorized technician.
Caution when used near easily inflammable and explosive materials. Please read the
safety data sheets. The motors are designed to operate without sparking but the device
is not protected from explosion.
Connect the disperser to a grounded mains socket only.
Make sure the device is placed on a stable surface.
When operating, wear suitable clothing and eye protection.
Caution: The tool and fluid for dispersion are heated by the energy input.