HYDAC HDA 5500-0-2-DC-006 (CM1k) - Manual (Page 18)

HDA 5500 for HLB 1000 and CS 1000
- 18 -
9 Digital display
9.1 Standard display
Point 7.2 lists the options which you can select as the primary display. The value set at any
one time is displayed permanently.
Hints:
• Initialisation of the HYDACLab ® can take up to 2 minutes; only once the initialisation has
been completed are the measured values meaningful.
• If the measured value exceeds the upper display range of the HDA 5500, then the
measured value can no longer be displayed. The upper display range flashes.
• If the measured value is less than 1 % of the lower display range, then the measured
value can no longer be displayed. The lower display range flashes.
9.2 Special display
If one of the measured values (temperature, rel. humidity, rel. change in viscosity or dielectric
constant when device HLB 1000 is selected, or CH1, CH2, CH3, CH4 when device CS 1000
is selected) is set as the primary display, then by pressing the
or keys the following
values can be displayed separately. These values are each displayed for approximately 3 s:
• Lowest value
• Peak value
• Status signal
The relevant lowest and peak values are reset by pressing the
and keys
simultaneously during normal operation. If the reset has been successful, rES (reset) is
displayed to confirm this.