HYDAC HDA 5500-0-2-DC-006 (CM1k) - Manual (Page 9)

HDA 5500 for HLB 1000 and CS 1000
- 9 -
Menu point Setting Setting range Default setting
Switching function switching output 3 (S.S.3)
Similar to switching output 1 (see above), and likewise for:
• Switching mode (S.M.3)
• Switching direction (S.d.3)
• Switch-on delay (T.on.3)
• Switch-off delay (T.oF.3)
r.ViS.
r.diE.
r.HuM.
TEMP.
SP
Win
on
oFF
0..99.99 s
0..99.99 s r.ViS.
SP
on
0
0
Switching function switching output 4 (S.S.4)
Similar to switching output 1 (see above), and likewise for:
• Switching mode (S.M.4)
• Switching direction (S.d.4)
• Switch-on delay (T.on.4)
• Switch-off delay (T.oF.4)
r.ViS.
r.diE.
r.HuM.
TEMP.
SP
Win
on
oFF
0..99.99 s
0..99.99 s r.ViS.
SP
on
0
0
Primary display (PriM)
Value which is displayed permanently:
Measured value of rel. change in viscosity
Lowest value of rel. change in viscosity
Peak value of rel. change in viscosity
Meas. value of rel. change in dielectric constant
Lowest value of rel. change in dielectric constant
Peak value of rel. change in dielectric constant
Measured value of rel. humidity
Lowest value of rel. humidity
Peak value of rel. humidity
Measured value of temperature
Lowest value of temperature
Peak value of temperature
Status of the HYDACLab (see Point 9.3)
r.ViS.
Min.V.
ToP.V.
r.diE.
Min.d.
ToP.d.
r.HuM.
Min.H.
ToP.H.
TEMP.
Min.T.
ToP.T.
STAT.
r.ViS.
Reset time (r.TiM)
Indicates how long in seconds the last peak / lowest value is
displayed for
0 .. 3.600 s
0