Johnson Systems J-PACK Series Dimmers User Manual
Page 27
27
31. SERIAL#
View the microcontroller’s unique eight-character silicone serial number.
XXXXXXXX
Shows the unique eight-character serial number.
32. VERSION
View the microcontroller’s software version.
VER X.X
Shows the microcontroller’s software version.
33. DEFAULTS
Set various system configuration settings to the factory default.
Press EXECUTE to enter the menu.
Press MENU ( ) to scroll through and select which item(s) to default.
3ØPATCH?
Sets the dimmer phase patch to ABCABC. This is the default setting.
1ØPATCH?
Sets the dimmer phase patch to ABABAB.
DMX PAT?
Clears the DMX patch and sets as invalid.
DCPATCH?
Clears the dimmer to channel patch and configures it for 1:1 operation.
CURVES?
Sets all 6 dimmer curve profiles to Square Law curve.
V-LIMIT?
Sets the output voltage limit to full (127.5 or 255) on all 6 dimmer outputs.
FD-TIME?
Sets the fade time at 5 seconds for all 6 scenes.
LOADSHD?
Clears load shed patch for both auxiliary inputs.
SURE???
Press EXECUTE to select the item to default. Are you sure?
DONE!!!
Press EXECUTE to set the selected default.
Press ESCAPE or RESET to exit the menu.
34. LED INT
Set the LED intensity for the programming switches.
Press EXECUTE to enter the menu.
LEV:100%
Press MENU ( ) to adjust the LED intensity from 0% to 100%.
LEV:050%
Press MENU ( ) and MENU ( ) at the same time to toggle back to 50%.
Press ESCAPE to exit the menu and save the desired setting.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.
35. LCD VIEW
Adjust the contrast of the LCD Display for optimum viewing.
Press EXECUTE to enter the menu.
ADJUST
Press MENU ( ) to adjust the LCD contrast.
Press ESCAPE to exit the menu and save the desired LCD view.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.