JUMO 706581 LOGOSCREEN nt Operating Manual - Manual (Page 136)

18 Configuration - Groups
136
Diagram header With the help of this parameter, the diagram header can be switched on or off.
The diagram header (numerical presentation of the measurements or switch
symbols for the binary channels) is available in the visualization mode Curves
and Binary.
Measurement
selection The parameter Measurement selection enables you to choose between MIN
and MAX. This setting exclusively affects the numerical measurement
presentation in the visualization mode Curves, but only if MIN and MAX values
are recorded at the same time. In the case of MIN and MAX value recording,
the recorder operates internally at the maximum sampling rate and stores both
the measured minimum and measured maximum within the active storage
cycle. Measurement selection determines which value is shown in the diagram
header.
MIN/MAX value recording is set through the parameter Stored values of the
operating modes (normal, event and timed operation).
Show envelope
diagram This parameter determines whether the measurement curves (only with
activated MIN/MAX value recording) are presented as an envelope or as a line
in the curve presentation. If the data are not recorded in the MIN/MAX value
recording mode, the parameter has no effect.
MIN/MAX value recording is set through the parameter "Stored values = MIN/
MAX values” of the operating modes (normal, event and timed operation).
Show binary
channels
(traces) This parameter determines whether the binary traces (binary signals) are
presented together with the analog signals in the curve display.
MIN Minimum values are displayed in the diagram
header.
MAX Maximum values are displayed in the diagram
header.
Yes MIN/MAX values are presented as an envelope.
No MIN/MAX values are presented as a line.
Yes Binary and analog signals are shown.
No The binary signals are not shown.