JUMO 706581 LOGOSCREEN nt Operating Manual - Manual (Page 81)

81
7 Memory Manager
Close memory
manager (Exit) Close the memory manager and reactivate the previous visualization.
Safely
removing
hardware The function should always be called before removing a CF card or a USB
stick. This is the only way to ensure that files are properly stored on the data
storage medium.
When the message "Hardware can be removed now" appears, the data
storage medium can be removed.
Update
CF card Measurement data not yet saved to a CF card (a USB stick) are written to the
data storage medium.
Backup ->
CF card All measurement data in the memory (also those which have already been
fetched) are written to the data storage medium.
Config data ->
CF card The configuration data and the user list (for password management) are
written to the data storage medium.
CF card ->
config. data Configuration data are read into the device from the data storage medium.
Save all +
update CF
card All current reports will be concluded and written to the data storage medium,
together with the measurement data that have not yet been saved. The
present counter and integrator states will also be saved.
Service data ->
CF card Special data are saved to the CF card. The function may only be carried out if
the user has been asked to do so by a service engineer from the instrument
manufacturer.
Software
update This function serves for reading in a new device software (firmware). To do this,
a special CF card is required. Only a service engineer from the instrument
manufacturer may perform the update.
CF card ->
user list The user list is read in from the data storage medium and activated in the
paperless recorder.
H
The functions of the memory manager are the same for CF cards
and USB memory sticks. For USB sticks, the menu entries have
"USB stick" instead of "CF card".
H
This will give the recorder a new configuration.
Subsequently, the data recording will be started again.