JUMO 706581 LOGOSCREEN nt Operating Manual - Manual (Page 152)

21 Configuration - Counters/Integrators
152
Type Type determines when the current count is stored. According to the setting,
the parameters from Chapter 21.1 "General Setting" must also be taken into
account.
The parameter Type is not available for measuring the flow rate quantity.
Ext. control
signal Selection of the control signal if Type “External” has been configured.
Additional
storage This parameter determines whether current states should be stored an
additional time. "Additional" means: in addition to storage resulting from the
Type parameter. Current states are stored but are not reset.
This parameter is not available for the function Flow rate quantity.
Specific
setting This parameter renders the times (not the Reset signal) from Chapter 21.1
"General Setting" ineffective.
The parameter is not available for the function Flow rate quantity.
Type Description
Periodic Conclusion and restart are determined by the
parameters Period and Synch. time.
External Conclusion and restart are determined by an ext. control
signal. The counters/integrators operate when the
external signal is set (HIGH).
Daily Daily defines that the counters/integrators are counted/
integrated over one day (24 hours). Conclusion and
restart are determined by the parameter Synch. time.
Weekly Weekly defines that the counters/integrators are
counted/integrated over one week. Conclusion and
restart are determined by the parameters Weekday and
Synch. time.
Monthly Monthly defines that the counters/integrators are
counted/integrated over one month. Conclusion and
restart will occur on the first day of the month at 00:00
hours.
Yearly Yearly defines that the counters/integrators are counted/
integrated over one year. Conclusion and restart will
occur on the first day of the year at 00:00 hours.
Total Total defines that the counters/integrators are counted/
integrated for the entire duration of the current
configuration.
Daily
(start — end) Daily (start...end) defines that the counters/integrators
are counted/integrated over a period within one day.
Restart and conclusion are determined by the
parameters Start and End.