B&B Electronics MES1A - Manual (Page 31)

Configuring the MES1A/B
Manual Documentation Number: MES1A/MES1B-2106m PN7138-rev001
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
21
12. To change the parameter, type in a new value, then press Enter. If
you wish to leave the parameter as it was, simply press Enter. A
prompt for the next parameter will appear.
13. When all parameters in the currently selected section are complete
you will again be prompted to select a menu item. Select another
section and continue the configuration process.
Saving Configuration Settings
When all categories have been configured you must save your configuration
to the MES1A/B.
To Save the configuration settings to the MES1A/B, at the Select
Command or parameter set (1..4) to change: prompt type S.
Quitting Without Saving
To Quit the configuration session without saving, type Q. The background
color will change to gray and the MES1A/B will re-start without updating the
configuration settings.
Reconfiguring to Factory Settings
The MES1A and MES1B come from the factory preconfigured for correct
operation with their respective interfaces. The following procedure describes
how you can return the MES1A and MES1B to their original factory settings.
To Reconfigure the MES1A to Factory Settings:
Type D at the Select Command or parameter set (1..4) to
change: prompt. The Configuration Menu is updated with the new settings
displayed.
To Reconfigure the MES1B, to Factory Settings:
14. Type D at the Select Command or parameter set (1..4)
to change: prompt.
15. Type 2 to enter the Serial & Mode Settings section and set the
Serial Mode for RS-485 Two-Wire (see the next section for
details).