Kisan Electronics ManualtailBlazer - Manual (Page 13)

Page - 11
100HD-M INSTALLATION:
This is a modified unit for
installation on bikes with
brake bulb monitoring.
For twin bulb type of taillight
arrangements, there’s
typically a “Y” harness
before it is split. In order to
modulate both bulbs
together, the correct location
for the splice is upstream of
the “Y” harness.
Once you have identified the
brake wire and chosen the
correct location to make the
splice, cut and prepare the wire
ends as shown here. If you
plan to use the rubber boot,
feed the wires though first by piercing a small hole at the tip of the boot.
Next, Insert the wire-ends and screw-in (3) connections as follows:
„ BRAKE INPUT - is for the stripped wire-end that supplies power.
„ OUTPUT to BULBS - is for the stripped wire-end going to the bulbs.
„ GROUND - is for the wire supplied with ring for attaching to chassis.
Use the Velcro to mount the unit in an appropriate location – away from
high heat or direct water spray.