Kisan Electronics ManualtailBlazer - Manual (Page 17)

Page - 15
25LED INSTALLATION:
This is a special unit designed for a
split voltage input of 6 volts for low
intensity running light and 12 volts
step-up for the brakes. 25LED
modulator fits the OEM Wing-light for
the GL1500 SE models.
25LED can be plugged in-line with the
connector on the back of the trunk lid
as shown. Use Velcro strip to mount
it.
2-pin input connector is polarized to
match with Gold Wing 1500 wiring.
The output pins are protected
internally, so reverse connection will
not harm the electronics. IF the
spoiler LEDs do not come on, check
the output pins for polarity and
connection.
The Running Light Intensity Adjustment is not available on this unit.
„ The step-up regulator of the SE models need minimum of 12.6 volts
input to function correctly. tailBlazer may not execute complete 4-sec
flash cycle without the engine running
„ To minimize false triggering from CB transmit function, reroute the
coaxial cable of the antenna which runs along the left hinge of the
trunk alongside the LED power wire. Separate them as much as
possible to eliminate any cross talk.