Lenze Global Drive Cam Loader - Manual (Page 7)

L
1.1 EN - 05/2005 7
Global Drive Cam Loader
System requirements
Connection with the target system
2 System requirements
The following minimum requirements on hardware and software must be met in order to
use the Cam Loader:
[ Microsoft® Windows NT® 4.0 (as of Service Pack 5), Windows® 2000
(as of Service Pack 2) or Windows XP
[ IBM®-compatible PC with Intel® Pentium® 90 processor
[ 128 MB RAM
[ 120 MB free hard disk capacity
[ Pointer device (mouse, track ball, etc.)
[ Free slots/interfaces according to the requirements of the fieldbus connection module
used.
2.1 Connection with the target system
The communication with the target system (controller, Drive PLC, etc.) requires a fieldbus-
specific interface module for the PC and the corresponding fieldbus modules for the target
systems to be connected.
For system bus (CAN) communication, Lenze offers the following components as interface
module for the PC:
Bus system Max. number of target systems
PC port Required hardware components
System bus (CANopen) 63
Parallel
port
(LPT port)
PC system bus adapter 2173
incl. connection cable and voltage-supply adapter
• for DIN keyboard connection
(EMF2173IB)
• for PS/2 keyboard connection
(EMF2173IBV002)
• for PS/2 keyboard connection with electrical isolation
(EMF2173IBV003)
USB
(Universal Serial Bus)
PC system bus adapter 2177
incl. connection cable
(EMF2177IB)