Memmert AtmoCONTROL FDA Version 2.X.X - Manual (Page 11)

D30396 | Date 09/2014 11
AtmoCONTROL FDA Version
When starting AtmoCONTROL FDA, you have to login as
AtmoCONTROL user with your user name and password. Users
are created and managed by the AtmoCONTROL administrator
(see page 33).
If unencrypted data of a previously installed version of At-
moCONTROL other than the FDA edition are detected when
you start AtmoCONTROL FDA for the first time, you are asked
whether these data should be encrypted. This is required for compliance with the FDA require-
ments. The data will however no longer be compatible with the standard version of Atmo-
CONTROL but only with the FDA edition.
4.2 Programme interface
The main programme interface window of AtmoCONTROL is divided into the following areas:
1
2
3
4
6
5
1 Menu bar (see section 4.2.1)
2 Toolbar (quick access to most important functions, see section 4.2.2)
3 Status bar (provides an overview of available appliances, see page 13)
Toolbar (quick access to most important functions, see section 4.2.2) Toolbar (quick access to most important functions, see section 4.2.2)
4 Show/hide status bar
Status bar (provides an overview of available appliances, see page 13) Status bar (provides an overview of available appliances, see page 13)
5 Editor, simulation and protocol window (only for appliances listed on page 8,
otherwise only protocol window)
Editor, simulation and protocol window (only for appliances listed on page 8, Editor, simulation and protocol window (only for appliances listed on page 8,
6 Programming mode switch (for editor/simulation/protocol, see pages 24 and 30)
otherwise only protocol window) otherwise only protocol window)
(only for appliances listed on page 8)
Programming mode switch (for editor/simulation/protocol, see pages 24 and 30) Programming mode switch (for editor/simulation/protocol, see pages 24 and 30)
You may change the language of the pro-
gramme interface at any time. German or
English can be set (OptionsLanguage).