Memmert AtmoCONTROL FDA Version 2.X.X - Manual (Page 25)

D30396 | Date 09/2014 25
AtmoCONTROL FDA Version
5.3.3 Transferring programme via Ethernet
To be able to transfer a programme via Ethernet, the appliance and computer must be
connected via Ethernet, the correct IP address set (see page 13) and the appliance
switched on.
Click ProgramUpload to device. The programme is uploaded to the appliance and can be
started there.
5.3.4 Transferring a programme via USB storage medium
1. Click ProgramExport to USB drive. The programme is saved on the USB storage medium
connected.
2. Connect the USB data medium to the appliance which is to run the program.
5.3.5 Selecting and starting a programme on the appliance
If the programme was transferred to the appliance via Ethernet or USB data medium, it can be
selected and started there.
How programmes are selected and started on the appliance is described in the user
manual for the appliance.
If the appliance is connected to the computer via the network, the respective current operat-
ing status can be monitored in the status bar of AtmoCONTROL (see page 13).
With appliances that have humidity control, make sure that the water supply tank of the
appliance is filled before the programme start. Check the level of the tank at regular inter-
vals, especially for programmes that run for long periods. The same applies for appliances
with gas supply.