MK Diamond CX-3 - Manual (Page 9)

9
• NEVER disconnect any “emergency or safety devices”. These devices are intended for
operator safety. Disconnection of these devices can cause severe injury, bodily harm or
even death! Disconnection of any of these devices will void all warranties.
• Unauthorized equipment modifications will void all warranties. Manufacturer does not
assume responsibility for any accident due to equipment modifications.
• NEVER use accessories or attachments, which are not recommended by MK Diamond for
this equipment. Damage to the equipment and/or injury to user may result.
WARNING
WARNING
NOTE:
DO NOT use woodcutting, or carbide blades on this machine! Use ONLY Diamond blades on
machine. Use machine only to cut concrete and asphalt. DO NOT use machine to cut wood or
wood products.
Exhaust gas from gasoline engines contain dangerous carbon monoxide. Breathing it can cause
unconsciousness and even kill you. Always operate gasoline engine machines in a well-ventilated
area DO NOT operate in areas where exhaust fumes could accumulate without wearing appropriate
respiratory protection.
The operator must be aware of the machine’s capabilities and limitations. It is
the operators responsibility to use this machine under safe working conditions
and conform with federal, state and local codes or regulations pertaining to
safety, air, pollution, noise etc...
Prior to operation of this machine the operator must determine the existence
and location of any subsurface features that may be hazardous or could dam-
age the equipment, (i.e. electric cable, natural gas line etc.)
Before starting the machine, ALWAYS check that all guards are in position and correctly fitted. Check
the machine for loose bolts before starting.
Keep area around the machine clear of obstructions which could cause persons to fall onto moving parts.
ALWAYS ensure that the machine is on level ground before using. Know how to stop the machine
quickly in case of emergency. NEVER try to stop a moving blade with your hands.
CX-3
®
PRE-START
WARNING
Diamond Blades improperly used are dangerous. Comply with American National Standards Institute
Safety Code, B7.1 and, Occupational Safety and Health Act covering Speed, Safety Guards, Flanges,
Mounting Procedures, General Operating Rules, Handling, Storage and General Machine Conditions.