MTS FlexTest Models 200 - Manual (Page 300)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Aero Multibox Overview
Aero Multibox Systems 300
Reflective Memory Module Node Address Jumper Settings
Each box in a dual-processor multibox system must have a reflective memory
module (VMIC) installed on the DSP processor board located in VME slot 3.
Each VMIC module must have a discrete Node ID number. The Node ID number
is set on the VMIC module using the E1 jumpers (see table below).
Note 7100 processors do not use the VMIC card. SCRAMNet GT memory
cards do not require any jumper settings.
VMIC Node Address Jumper Settings
C HASSIS N ODE
ID N UMBER
P INS
1 TO 2
P INS
3 TO 4
P INS
5 TO 6
P INS
7 TO 8
P INS
9 TO 10
P INS
11 TO 12
P INS
13 TO 14
P INS
15 TO 16
0 (Box 1) Install Install Install Install Install Install Install Install
1 (Box 2) Remove Install Install Install Install Install Install Install
2 (Box 3) Install Remove Install Install Install Install Install Install
3 (Box 4) Remove Remove Install Install Install Install Install Install
4 (Box 5) Install Install Remove Install Install Install Install Install
5 (Box 6) Remove Install Remove Install Install Install Install Install
6 (Box 7) Install Remove Remove Install Install Install Install Install
7 (Box 8) Remove Remove Remove Install Install Install Install Install
8 (Box 9) Install Install Install Remove Install Install Install Install
9 (Box 10) Remove Install Install Remove Install Install Install Install
10 (Box 11) Install Remove Install Remove Install Install Install Install
11 (Box 12) Remove Remove Install Remove Install Install Install Install
Model 498.96
Proc CPU 1 Board
VME Slot 3
E1
15
11
9
7
5
3
1
13
16
12
10
8
6
4
2
14
E1 Jumpers
Bottom View
Memory Module
Top View
Memory
Module
Node ID numbering
convention:
Box 1 = Node 0,
Box 2 = Node 1,
Box 3 = Node 2...