MTS FlexTest Models 200 - Manual (Page 269)

Model 494.75 8-Input BNC Transition Board
MTS FlexTest® Models 40/60/100/200 Controller Hardware Digital I/O and Transition Boards 269
Model 494.75 8-Input BNC Transition Board
About the Model 494.75 8-Input BNC Transition Board
Analog input signals are typically routed to the Model 494.45 A/D Converter
mezzanine card through a Model 494.75 8-Input BNC Transition Board. The
two outputs of this transition board connect to the front-panel RJ-50
connectors on the I/O carrier board associated with the A/D converter
mezzanine card (J3A and J3B).
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors with a gray boot.
The use of other RJ connectors (less than 10 pins or unshielded with a
black boot) with the I/O carrier board can cause component damage.
Only use transducer cables equipped with 10-pin, braided shield, RJ-50
connectors (with a gray boot) with the I/O carrier board.
CAUTION
First
494.76
ANALOG OUTPUT CH 1 - 8
Last
J11
J12
1 2 3 4 5 6 7 8
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
Model 494.75 8-Input
BNC Transition Board Model 494.40 I/O Carrier Board
Transition
Card Cage
VME Card Cage Analog
Input
Devices
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Input 8
Input 1-4
Input 5-8
494.45 8-Input
A/D
Mezzanine Card