MTS Multipurpose Simulated - Manual (Page 32)

Precrack Parameter Values
Value to Use for Simulation Parameter
25 mm Precrack Final Crack Limit
10 Hz Precrack Frequency
0.100 unitless Precrack Load Ratio
10% Precrack Lower Least Squares Fit
Percentage
90% Precrack Upper Least Squares Fit
Percentage
1000000 count Precrack Cycle Limit
0.348 kN/mm^1.5 Precrack Final Maximum K
The following table lists the COD (Crack Opening Displacement) parameter values.
COD Parameter Values
Value to Use for Simulation Parameter
COD Control Mode
0.03 mm/sec Ramp Rate
The following table lists the data storage parameter values.
Data Storage Parameter Values
Value to Use for Simulation Parameter
0% Precrack Save Percent Limit
100 Store Every Nth Precrack Cycle
20 Hz CTOD Data Frequency
100 N Delta Force
The following table lists the test termination parameter values.
32 MTS TestSuite
5.0 Running Simulation Tests