MTS Multipurpose Simulated - Manual (Page 79)

Precrack Parameters
Description Parameter
Specify the number of precrack cycles
completed. Precrack Cycles
Completed
Specify the final crack size calculated from
compliance. Precrack Final Crack Size
Specify the final load during precrack. Precrack Final P
Specify the maximum load measured during
precrack. Precrack P Maximum
Specify the final K during precrack. Precrack Final K
Specify the maximum K value during
precrack. Precrack K Maximum
Specify any additional comments. Precrack Comments
5.5.2.10.0 Calculator
Use the Calculator to calculate the load to use for new specimens.You can also use the Calculator to calculate
stress intensity (K). Load is calculated from the crack size value and stress intensity (K) value. Stress intensity
(K) is calculated from the crack size value and load value.
Typically, you use the Calculator after the crack size is checked. If the crack size check is performed, the
software supplies the crack size value for the Calculator. You can also enter a crack size value manually.
You must enter the load or stress intensity value manually.
The following table lists the load P parameters.
Load P Parameters
Description Parameter
Specify the crack size value to use in the load
calculation. Crack Size
Specify the stress intensity (K) value to use
in the load calculation. Stress Intensity K
The following table lists the stress intensity K parameters.
MTS TestSuite 79
5.0 Running Simulation Tests