Basic engine – Multiquip WM70SH8C User Manual

Page 18

Advertising
background image

page 18 — WM70SH5C/WM70SH8C Mixer • operaTion and parTS Manual — rev. #0 (06/07/11)

Figure 7. Engine Components

iniTial ServiCing

The engine (Figure 7) must be checked for proper

lubrication and filled with fuel prior to operation. Refer to the

engine manufacturer’s manual for instructions and details

of operation and servicing.
1.

Fuel Filler Cap — Remove this cap to add unleaded

gasoline to the fuel tank. Make sure cap is tightened

securely.

do noT over fill.

1

2

3

4

5

6

7

8

9

10

danger

Adding fuel to the tank should be done

only when the engine is stopped and has

had an opportunity to cool down. In the

event of a fuel spill,

do noT attempt to

start the engine until the fuel residue has

been completely wiped up, and the area surrounding

the engine is dry.

2.

Throttle lever — Used to adjust engine RPM speed

(lever advanced forward SLOW, lever back toward

operator FAST).

3.

engine on/oFF Switch — ON position permits engine

starting, OFF position stops engine operations.

4.

recoil Starter (pull rope) — Manual-starting method.

Pull the starter grip until resistance is felt, then pull

briskly and smoothly.

5.

Fuel valve lever — OPEN to let fuel flow, CLOSE to

stop the flow of fuel.

6.

Choke lever — Used in the starting of a cold engine,

or in cold weather conditions. The choke enriches the

fuel mixture.

7.

air Cleaner — Prevents dirt and other debris from

entering the fuel system. Remove wing-nut on top of

air filter cannister to gain access to filter element.

8.

Spark plug — Provides spark to the ignition system.

Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch)

Clean spark plug once a week.

9.

Muffler — Used to reduce noise and emissions.

10.

Fuel Tank — Holds unleaded gasoline. For additional

information refer to engine owner's manual.

NOTICE

Operating the engine without an air filter, with a

damaged air filter, or a filter in need of replacement will

allow dirt to enter the engine, causing rapid engine wear.

Warning

Engine components can generate extreme

heat. To prevent burns,

do noT touch

these areas while the engine is running or

immediately after operating.

never operate

the engine with the muffler removed.

basiC enGine

Advertising
This manual is related to the following products: