Multiquip WM70SH8C - Manual (Page 21)

WM70SH5C/WM70SH8C Mixer • operaTion and parTS Manual — rev. #0 (06/07/11) — page 21
start-up
6. Place the belt slip lever (Figure 14) in the START/STOP
(disengaged) position.
Figure 14. Belt Slip Lever
(Start/Stop Position)
Figure 15. Drum Lock Pin (Side-View)
START/STOP
POSITION
BELT SLIP
LEVER
CauTion
Make certain the drum lock pin (Figure 15
and Figure 16) is placed to the RIGHT (when
viewing the mixer from the towpole end) of
the drum stop block which is welded to the
front side of the drum. Also make sure lock pin is fully
engaged (locked). This will prevent the drum from tipping.
DRUM
FRONT
POST
LOCK
PIN
Figure 16. Drum Lock Pin (Right Position)
7. Pull the starter grip (Figure 17) lightly until you feel
resistance, then pull briskly. Return the starter grip
gently.
Figure 17. Starter Grip
8. Place the belt slip lever (Figure 18) in the mix position.
This will tilt the engine placing tension on the V-belts
enabling the shaft to rotate.
Figure 18. Belt Slip Lever (Mix Position)
DRUM LATCH
PIN
STOP
BLOCK
TOW OR LOCKED
POSITION
MIX
POSITION
BELT SLIP
LEVER