Multiquip LT6K - Manual (Page 26)

page 26 — LT6K LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #1 (08/28/14)
Figure 7. Kohler Engine Components
1
2
3
1
5
4
7
6
19 18
11
12
10
9
8
14
16
17
15
13
1. engine status module — Displays engine status/
alarms for high water temperature, low oil pressure,
pre-heat, charging system, and air filter.
2. Starter — Starts engine when ignition key is rotated
to the " START" position.
3. Fuel Filter — Filters fuel for contaminants.
4. Engine — 3-cylinder, water cooled, direct injection, 12
HP diesel engine.
5. Air Filter — Prevents dirt and other debris from
entering the fuel system. Unsnap air filter cover to gain
access to filter element.
6. Oil Filler Cap — Remove to add engine oil. Reference
Tables 4 and 6 when adding engine oil.
7. Emissions Tag — Provides emissions model
identification and information.
8. glow plugs (3) — Used in the starting of the engine.
In cold weather conditions, allow the glow plugs to be
warmed before starting the engine.
9. Oil Pressure Sensor — Monitors engine oil pressure.
In the event of low oil pressure will shut down the
engine.
10. Lifting Bail (2) — When lifting of the engine is required,
attach a strap or chain of adequate lifting capacity to
these lifting points.
11. Oil Dip Stick — Remove to check amount and
condition of oil in crankcase.
12. Oil Filter — Spin-on type, filters oil for contaminants.
13. Engine Tag — Provides engine model identification
and information.
14. muffler — Used to reduce noise and emissions.
15. Oil drain plug (2) — Remove to drain crankcase
oil. Always dispose of used oil and oil filters in an
environmentally safe manner. dO nOT allow used oil
to drain onto the ground or into a water runoff drain.
16. Alternator — Provides power to the electrical system.
Replace with only manufacturer's recommended type
alternator.
17. Fan Guard — Protects personnel from rotating fan
blades.
18. Radiator — Use only recocoolant/anti-freeze. Radiator
coolant capacity is 5.18 gallons (4.9 liters).
19. v-Belt — ALWAYS make sure the V-belt is properly
tensioned. A loose or defective V-belt can adversely
affect the performance of the engine.
WaRnIng
Engine components can generate extreme
heat. To prevent burns, dO nOT touch
these areas while the engine is running or
immediately after operating. neveR operate
the engine with the muffler removed.
engine components