Opticon PHL 7200 User Manual - Manual (Page 106)

OPTICON
User's manual
PHL-7000 series
3-43
3.2.15 Power
ICON
ITEM & FUNCTION
•
“Battery” Tab (Figure 3-72) :
9
Provide change level indicators for Main battery and
Backup battery.
9
Provide remaining power capacity of main battery.
9
If a “Main Batteries very Low” warning message shows, the
remaining battery life is around 30 minutes before PDT
shuts down. (Figure 3-76)
9
The PDT will shutdown if the main batteries capacity is
around 0%
9
To exit Battery control panel, press “OK” from the
command bar, or press <Enter> key on keypad.
•
“Schemes” Tab (Figure 3-73) :
9
The Scheme Tab allows you to determine the time to
switch state to Suspend mode when using either Battery
Power or AC Power.
9
Select Battery Power or AC Power as the power scheme
from the pull-down list. (Figure 3-73)
9
Select the time to suspend mode from the pull-down list.
(Figure 3-74)
•
“Device Status” Tab (Figure 3-75) :
Provide power level of the device – The power level ranges
from “High(D0)” which means the device is at the highest power
level to “Off(D4)” which means the device is at the lowest power
level.
Note:
This ICON inside the Task Bar shows that AC adapter provides
power to the PDT
The ICON inside the Task Bar shows that Main Batteries
provides the power to the PDT.
The ICON inside the Task Bar shows that AC adapter provides
the power to the PDT and is charging the main batteries..
Table 3-23 Power