Opticon PHL 7200 User Manual - Manual (Page 55)

OPTICON
User's manual
PHL-7000 series
2-36
Figure 2-18 Date/Time properties
2.5 Navigating the Display
2.5.1 Setting Time and Date
In the Date/Time options, you can change the year, month, date, time, time zone, or select
automatic adjust for daylight saving time. To set or change the date and time:
1. Select Start > Settings > Control Panel >
Date/Time.
2. To change the year, select the year. Select the up
arrow to increase the value, select the down
arrow to decrease the value. Or you can type a
new value in the field.
3. Select the month to open a pull-down list of
months or press the arrow buttons to either side
of the month to increase or decrease the month.
4. To change the time, select the hour, minute,
seconds, or AM/PM and select the up arrow to
increase the value; select the down arrow to
decrease the value. Or you can type a new value
in the field.
5. Select your correct time zone from the pull-down
list.
6. To automatically adjust the clock for daylight
saving time, enable the checkbox at the bottom
of the screen.
7. Select Apply to save your changes or select OK to exit the Date/Time settings.
2.5.2 Entering the Data
To select and open programs, select Start > Programs from the task bar to open a list of
available programs. If the program has an icon on the desktop, double-tap to open it.
There are several ways to enter data in an application on the PDT:
z
Use the keypad to enter alpha-numeric characters, Refer to “2.4.7 Using the PHL-7100
keypad” and “2.4.8 Using the PHL-7200 keypad” .
z
Use the stylus on the touch screen, Refer to “2.4.6 Using the stylus”.
z
Select text in the same way you select the text on a PC. Use the stylus to highlight the
desired text by dragging the stylus across the desired text, double-tapping to select one
word and triple-tapping to select an entire line/paragraph. Refer to “2.4.6 Using the
stylus”.
z
Use the soft input panel with the stylus. Refer to “2.5.5 The Soft Keypad”
z
Use the bar code reader to input the data from a bar code. Press one of the three trigger
keys to start the bar code reader. The bar code data will enter in the current application’s
open window.
For more information on factory installed applications, Refer to Chapter 5 “Software
Applications”.