Body Solid G2B - Manual (Page 10)

1
mm
Inch
10
S T E P
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until the end of step 4.
A. Attach three Weight Stack Shims (20) to the bottom of Main Base Frame (A).
Insert one Foot Cap (11) into the end of Rear Base Frame (B).
Insert one Convex End Cap (17) to Main Base Frame (A) as shown.
Attach two Frame Levelers (19) to Main Base Frame (A).
Attach one Frame Leveler (19) to Rear Base Frame (B).
B. Attach Main Base Frame (A) to Rear Base Frame (B) and Rear Vertical Frame (C) using:
Two 50 (1/2” x 3 1/2” hex head bolt)
Four 69 (1/2” washer)
Two 66 (1/2” nylon lock nut)
Two 61 (5/16” x 3/4” allen bolt)
Two 72 (5/16” washer)
C. Insert one Convex End Cap (17) to the top of Rear Vertical Frame (C) as shown.
Insert two Round End Caps (9) to the openings in Main Base Frame (A) as shown.