Body Solid G2B - Manual (Page 18)

5
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
18
S T E P
A. Slide two Nylon Bushings (13) into Back Pad Holder (S).
Attach Back Pad Holder (S) to Angled Vertical Frame (D) using:
Two 54 (3/8” x 2 3/4” hex head bolt)
Four 70 (3/8” washer)
Two 67 (3/8” nylon lock nut)
B. Attach End Cap (17) to the end of Back Pad Adjuster (T).
Slide Back Pad Adjuster (T) into Back Pad Holder (S). Use the T-Shaped Pop Pin (106) and
One 91 (5/16” x 3/4” socket head allen bolt)
to hold in place.
C. Insert two End Caps (16) to the top and bottom of Back Pad Frame (U).
Attach Back Pad Frame (U) to Back Pad Adjuster (T) using the Pop Pin (90) and:
One 92 (3/8” x 5/8” allen bolt)
One 93 (3/8” washer)
D. Attach Leg Hold Downs (V) and (W) to the Angled Vertical Frame (D) as shown using:
Two 55 (3/8” x 3” hex head bolt)
Four 70 (3/8” washer)
Two 67 (3/8” nylon lock nut)
The Leg Hold Downs are marked with an L and R to indicate left and right, They should angle
forward and upward.
E. Slide two Rollers (30) onto Right and Left Leg Hold Downs (V) and (W) and hold in place with two
Roller End Caps (41).
Note:
You should now wrench tighten all bolts and nuts in this step.