Body Solid G2B - Manual (Page 12)

mm
Inch
2
Be careful to assemble all components
in the sequence they are presented.
12
S T E P
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until the end of step 4.
A. Attach Angled Vertical Frame (D) to Main Base Frame (A) using:
Two 55 (3/8” x 3” hex head bolt)
Four 70 (3/8” washer)
Two 67 (3/8” nylon lock nut)
B. Attach Top Main Frame (E) and Flat Plate (F) to Rear Vertical Frame (C) using:
Two 54 (3/8” x 2 3/4” hex head bolt)*
Two 70 (3/8” washer)
*NOTE
These two bolts (54) go into internal threads inside Top Main Frame (E).
C. Attach Top Main Frame (E) and Flat Plate (G) to Angled Vertical Frame (D) using:
Two 55 (3/8” x 3” hex head bolt)
Four 70 (3/8” washer)
Two 67 (3/8” nylon lock nut)
D. Insert Convex End Cap (18) to the front of Top Main Frame (E).
Insert Convex End Cap (18) to the small arm sticking out of Angled Vertical Frame (D) as shown.