Precision Turbo and Engine BigStuff3 GEN3 PRO SEFI (LS1) System Hardware & BigComm Software - Manual (Page 100)

BigStuff3 Pro SEFI System (LS1)
Version 1.0 99
Once the “Default Dash” has been saved, individual dash’s can be changed and saved again as
part of the compilation of dash’s referred to as the “Default Dash”.
The steps for saving a reconfigured Dash, so that it becomes part of the “Default Dash”, are
outlined below:
• After configuring a Dash hit OK at the bottom of the Dash Setup window. The
window will close.
• Go back to Dash on the Main Window tool bar and Select Save To File from the
Dash drop down list. The screen below will open
Note: Before saving the Log Window dash for the first time, you need to
navigate to the C: Program Files/BigStuff/BigComm directory. This step
only occurs the very first time any Dash file is saved. Subsequent Dash file
saves will automatically be saved to the C: Program
Files/BigStuff/BigComm folder.
• Name the file “Default” and hit Save. By selecting “Default” as the file name, the
Log Window dash becomes part of the compilation called “Default Dash”. Again,
the file will be saved to C:/Program Files/BigStuff/BigComm directory.
• A unique file name can also be assigned by typing the name in the “File Name” sub-
window and clicking on Save.