Precision Turbo and Engine BigStuff3 GEN3 PRO SEFI (LS1) System Hardware & BigComm Software - Manual (Page 98)

BigStuff3 Pro SEFI System (LS1)
Version 1.0 97
After selecting a Dash to configure, “Signals” need to be selected and added to the Dash. After
the Signals are selected, added and saved, they will be displayed in the Dash at the bottom of the
relevant BigComm software screens. The left side of the drop down screen below shows the
“Available Signals”. The right side of the drop down screen below shows the “Signals in the
Dash”. To add Signals to the Dash, highlight a desired Signal on the left and click Add. The
Signal will move to the right side of the screen (Signals in the Dash). All Signals shown under
“Signals in the Dash” will now appear in the Cranking Fuel screen when that screen is used to
calibrate the Cranking Fuel.
In the Cranking Fuel example below, Air Temp, Base Injector Pulse Width, Coolant, MAP and
TPS where selected and added to “Signals in the Dash”.
This is the list of thirty-one (31)
available Dashboards. Once
configured, these Dashboards
will show up at the bottom of the
corresponding operating screens.