MacDon M205 Operators Manual - Manual (Page 138)

OPERATOR’S STATION
Switching the Installed Header Sensors On or Off
You can selectively enable or disable header sensors in the event of a malfunction or as part of a
troubleshooting routine.
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
• Disabled sensors flash the word SENSOR on CDM during regular operation.
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press SELECT (C) until DIAGNOSTIC MODE? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right (B) arrow to select Yes. Press SELECT (C).
• VIEW ERROR CODES? is displayed on the
upper line.
Figure 3.153: CDM Programming Buttons
5. Press SELECT (B) until ENTER SENSOR SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select Yes. Press SELECT (B).
• KNIFE SPEED SENSOR is displayed on the
lower line.
• ENABLE/DISABLE is displayed on the lower line.
Figure 3.154: Selecting Diagnostic Functions
169887 122 Revision A