MacDon M205 Operators Manual - Manual (Page 382)

MAINTENANCE AND SERVICING
1. Shut down engine and remove key. Turn lights ON.
2. Loosen bolt (A) and nut (B) (located inside light /
mirror support).
3. Position light to desired position.
4. Tighten bolt (A) and nut (B).
Figure 5.163: HID Auxiliary Lights
Replacing HID Lamp (if Installed)
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
To remove and replace the lamp only, follow these steps:
1. Shut down engine and remove key. Turn lights OFF.
NOTE:
Hold onto the handholds (A) on the cab front
corners and stand on the header anti-slip strips,
or stand on the maintenance platform when
accessing the HID auxiliary lights.
Figure 5.164: Cab Forward Handholds
2. Remove the nut, spring washer, and bolt (A) that
secure the lamp (B) to lamp bracket (C).
3. Remove lamp (B).
4. Position the new lamp (B) in lamp bracket (C) and
secure with bolt (A), spring washer, and nut.
5. Adjust lamp (B) to desired position and tighten bolt (A).
Figure 5.165: HID Auxiliary Lights
169887 366 Revision A