Retsch TG 200 - Manual (Page 16)

2/25/2013

Retsch GmbH
16
0002
Drying mode
Storage and recalling drying parameters
2 5 8 10 11 13
You can store, change or overwright the drying parameters temp –
air flow – interval and time at any time in the programme
positions P1 to P9.
After switching on the TG200 the indication “on” appears in the
display 2.
By pressing the key PROG the next programme position P1 to P9
can be reached. After programme position P9 on reappears in the
display. In the PROG mode all keys except PROG, START and
STOP are inhibited.
 on = free adjustment of the drying parameters 5/8/10-11
and 13 is possible, or
 P1 to P9 = parameters can be saved and recalled here
 Start = drying process is started with the parameters
stored in programme position P1 to P9.
Allocation of storage location
 Press PROG key until required storage location P1-P9 has
been reached.
 Press SET key – all displays flash
 Set drying parameters 5/8/10-11/13
 Press SET key; values are stored
Flashing of the display stops, the adjustment inhibitor is
activated and sieve parameters are stored. In the PROG
mode all keys except PROG, START and STOP are inhibited.
Signal tone for end of drying process
If the drying process is brought to an end within a definite time
without interruption, the end is signalled by an acoustic signal
tone which is sounded 5 times.