Robustel R3000 User Guide - Manual (Page 46)

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 45 / 131
Confidential
Status @ WiFi
BSSID
Show MAC address of R3000’s WiFi interface or the access point which
R3000 connects to.
Null
SSID
Show SSID of R3000’s WiFi interface or the access point which R3000
connects to.
Null
Mode Show current mode of R3000: AP or Client. Null
Key Management
Show current security mode of R3000 or the access point which R3000
connects to.
Null
Cipher Pairwise Show current encryption algorithm of R3000 or the access point which
R3000 connects to.
Null
Cipher Group
WPA State
Show current WPA status. Mainly there are 5 statuses: Disconnected,
Scanning, Initializing, Associated, 4way_handshark, Completed.
Disconnected: Not associated or connected with any access point,
perhaps because the wireless device has not fully initialized, is out of
range, or the wireless interface is disconnected because the Ethernet
interface is enabled.
Scanning: Searching for a wireless network (access point) for
connection.
Initializing: R3000 is setting up initial wireless environment.
Associated: This state is entered when the driver reports that
association has been successfully completed with an AP, but still waiting
for authentication.
4way_handshark: This state is entered when WPA/WPA2 4-Way
Handshake is started. When Passphrase do not match, it will show this
status.
Completed: The wireless connection of R3000 and other wireless
devices are established.
Null