Robustel R3000 User Guide - Manual (Page 69)

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 68 / 131
Confidential
This command sets the specified interface to passive mode. On passive mode
interface, all receiving packets are processed as normal and Rip info does not
send either multicast or unicast RIP packets except to RIP neighbors specified
with neighbor command.
The default is to be passive on all interfaces.
Enable Default
Origination
Enable to make router send the default route to the other routers which in the
same IGP AS.
Disable
Enable Redistribute
Connect
Redistribute connected routes into the RIP tables. Disable
Enable Redistribute
Static
Redistributes routing information from static route entries into the RIP tables. Disable
Enable Redistribute
OSPF
Redistributes routing information from OSPF route entries into the RIP tables. Disable
Network List Router will only report the RIP information in this list to its neighbor. Null
Network Address Enter the Network address which Eth0 or Eth 1 connects directly. Null
Netmask Enter the Network’s Netmask which Eth0 or Eth 1 connects directly. Null
OSPF @ IP Routing
Item Description Default
OSPF
OSPF (Open Shortest Path First) is a link-state routing protocol for IP networks. It
uses a link state routing algorithm and falls into the group of interior routing
protocols, operating within a single autonomous system (AS).
Null
Enable OSPFv2 Tick to enable OSPF function. Disable
3.22 Configuration -> DynDNS
This section allows users to set the DynDNS parameters.