Robustel R3000 User Guide - Manual (Page 92)

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 91 / 131
Confidential
This section allows users to set the IP Pass through parameters.
IP Passthrough
Item Description Default
Enable IP Passthrough
Tick to enable IP Passthrough feature.
Note: Firstly you need to select “Cellular” as “Primary Interface” in tab
“Configuration”-> “Link Management”.
Disable
Mode User can only select “PPPoE” mode at present. PPPoE
Ethernet Interface
Set the LAN interface from “LAN_0”, “LAN_1”.
PPPoE client dials up to R3000 (PPPoE server) corresponding to different LAN
interface. For example when you select “LAN_0” and connect PPPoE client (such
as PC) to LAN 0 through Ethernet cable, PC will dial up to R3000 (PPPoE server)
through LAN 0.
Note: It doesn’t matter whether you select “LAN_0” or “LAN_1” If you click to
enable “Enable Bridge” in tab “Configuration” -> “Ethernet” -> “LAN Interface”.
LAN_0
Username Set the username of PPPoE server. Null
Password Set the password of PPPoE server. Null
AC Name Set the AC (Access Concentrator) name of PPPoE server. Null
Service Name
Set the service name of PPPoE server.
Note: PPPoE client needs to set the same username, password, AC name, service
name of PPPoE server, or it cannot succeed to dial up to PPPoE server.
Null
Authentication
Set the different PPP authentication from “Auto”, “PAP”, “CHAP”.
Auto: Automatic detection.
PAP: Password Authentication Protocol
CHAP: Challenge Response Protocol
Auto
Link Detection
Interval(s)
When PPPoE client dial up to R3000 (PPPoE server), R3000 will send “LCP Echo
Request” to PPPoE client after this interval. “Link Detection Interval” ranges from
3 to 30 times.
30
Link Detection Max If R3000 re-sends “LCP Echo Request” packet continuously for Max Retries times 5