Robustel M1000 User Guide - Manual (Page 55)

Robustel GoRugged M1000 User Guide
RT_UG_M1000 _v.2.0.0
20.12.2013 54 / 83
Confidential
Note:
1. ATA is the Answer command. ATS0=<x> is the auto-answer command. The AT&W command helps to save the
current settings to the modem.
2. It is much easier to activate Auto-answer using Modem Configurator. Input the number of rings to wait in the
input box and then click Rings Auto-answer.
3. To disconnect the modem, type +++. The modem will respond with OK, which means that you have already
switched back to command mode.
4. Type ATH and press Enter to disconnect.
4.3 Using Short Message Service by Using AT Commands (Only Available
under Normal Mode)
GSM technology offers the benefit of using SMS (short message service) as an easy way to communicate over the
mobile network.
The following topics are covered in this chapter:
1. Sending a Short Message
2. Reading a Short Message
3. Deleting a Short Message
Note: Please enable the following option under Config Mode, then switch back to Normal Mode.