Black Box FX160A - Manual (Page 56)

PHONE LINE MANAGER 16 X 4
57
19. System Timing Parameters
19.1 About System Timing Parameters
The default value for the system timing parameters should be suitable for most applications and will never
need to be changed. There may be some changes you will want to make which will affect the operation of
the system under certain conditions. Any changes made affect all outside lines and all extensions.
19.2 Changing System Timing Parameters
The command to change the system timing parameters requires that each setting be entered in the order
shown. If you are modifying only a few of the settings in the list, you should enter the default value, shown
with an “*” for other parameters which you do not intend to change.
1. In the programming mode, enter 727.
19.3 Delay After Each RS-232C Character
This determines the amount of delay inserted after a character is sent across the RS-232C port to the printer
or PC. This setting is important only if you directly connect a computer or dedicated printer to the RS-232C
port.
2. Enter the two-digit code for the character delay
00 0 milliseconds
* 01 8 milliseconds
02 16 milliseconds
...
99 792 milliseconds
19.4 Delay After Each RS232C Line
This determines the amount of delay inserted after each line of Call-History information is sent across the
RS-232C port to the printer or PC. This setting is important only if you directly connect a computer or
dedicated printer to the RS-232C port.
3. Enter the two-digit code for the line delay:
00 0 milliseconds
01 16 milliseconds
...
* 04 64 milliseconds
...
99 1584 milliseconds