Belkin PM01122EA User Manual
Page 27
25
N Wireless Router
sections
table of contents
1
2
3
4
6
7
8
9
10
5
alTeRNaTe seTUP MeTHod
setting your Internet service Provider (IsP)
Connection Type to static IP
A static IP address connection type is less common than other
connection types. If your ISP uses static IP addressing, you will
need your IP address, subnet mask, and ISP gateway address. This
information is available from your ISP or on the paperwork that your
ISP left with you. Type in your information, then click “Apply Changes”
(4). After you apply the changes, the Internet Status indicator will read
“Connected” if your Router is set up properly.
1� IP address (1)
Provided by your ISP. Enter your IP address here.
2� subnet Mask (2)
Provided by your ISP. Enter your subnet mask here.
3� IsP gateway address (3)
Provided by your ISP. Enter the ISP gateway address here.
(1)
(2)
(3)
setting your IsP Connection Type to PPPoe
Most DSL providers use PPPoE as the connection type. If you use a DSL
modem to connect to the Internet, your ISP may use PPPoE to log you
into the service. If you have an Internet connection in your home or small
office that doesn’t require a modem, you may also use PPPoE.
Your connection type is PPPoE if:
1)
Your ISP gave you a user name and password,
which is required to connect to the Internet.
2)
Your ISP gave you software such as WinPOET or
Enternet300 that you use to connect to the Internet.
3)
You have to double-click on a desktop icon other
than your browser to get on the Internet.