SATEC EM920 Operation Manual User Manual
Operation manual, Power quality and revenue meter em920
Advertising
Table of contents
Document Outline
- Introduction
- Operating the EM920
- Meter Assembly
- Controls and Indicators
- TEST Mode
- Device Diagnostics
- Meter Security
- Meter Clock and Time Synchronization
- Monitoring the Meter Battery
- Billing and Energy Metering
- Instrumentation Metering
- Demand Forgiveness (Cold Load Pickup)
- Instrument Transformer Correction
- Power Transformer/Line Loss Compensation
- Operating Digital Inputs
- Operating Relay Outputs
- Operating Analog Outputs
- Operating the Logical Controller
- Operating the Event Recorder
- Operating the EN50160 Power Quality Recorder
- Operating the Fast Transient Recorder
- Operating the Fault Recorder
- Communicating with the EM920
- Auxiliary AC/DC Backup Power Supply
- Using Front Display
- Using PAS Software
- Configuring the EM920
- Configuring Communications
- General Meter Setup
- Basic Meter Setup
- Device Options and Mode Control
- Instrument Transformer Correction Setup
- Transformer/Line Loss Compensation Setup
- Local Settings
- Display Setup
- Configuring Digital Inputs
- Configuring Relay Outputs
- Configuring Analog Outputs
- Using Counters
- Using Periodic Timers
- Using Control Setpoints
- Configuring Billing/TOU
- Configuring Recorders
- Configuring the EN50160 Recorders
- Configuring Communication Protocols
- Configuring Meter Passwords
- Device Control and Upgrading
- Monitoring Meters
- Retrieving and Storing Files
- Viewing Files and Reports
- Parameters for Monitoring and Logging
- Setpoint Parameters
- Analog Output Parameters
- Billing and Load Profile Log Files
- EN50160 Statistics Log Files
- EN50160 Evaluation and Recording
- Data Scales
- Device Diagnostic Codes