SciGene 400 Hybridization Incubator - Manual (Page 5)

Model 400 Hybridization Incubator — USER MANUAL
Version 2.1, February 2011 (408) 733-7337, [email protected] 4
II. UNPACKING AND SETTING UP YOUR OVEN
A. Removing the Unit from the Carton
Open the shipping carton and remove the foam inserts from the top of
the unit. Position the shipping carton on the floor close to the location of
intended installation. Remove the foam inserts from the top of the unit.
Position a person in front and a person in back of the oven. Grip the
recessed edges along the top of the unit and lift it straight up and out of
the shipping carton taking care to keep it balanced. Place it on the bench
or table where it will be installed.
Carefully inspect the unit for damage. If there is evidence of damage,
keep the shipping materials as they may be needed to return the unit.
B. Parts Provided
Items are generally shipped in two boxes as follows:
 Large Box (23” x 25” x 26”)
o
Rotating Oven
o
Power Cord
o
User Manual
o
Tube Gripper
o
Tube Rotator, standard 10/20 (Cat. #1040-21-1)
 Small Box (15” x 15” x 6”)
o
Stainless Steel Drip Pan (Cat. #1040-20-5)
o
Hybridization Tube, 35x300mm, qty 1 (Cat. #1040-01-0)
Please verify that all items are received and are in good condition.
C. Installation
1. Placement
Place the unit on a stable, level surface within a few feet of the
power source. Avoid locating it below a shelf where solutions are
stored. A spill may enter the electrical compartment through the
vent holes on the top of the unit and cause damage. Ensure there
is adequate clearance along the front and right side of the oven to
open the door completely. There should be a minimum clearance
of 3 inches along the top and back panels for air circulation.
2. Connecting the Power
Plug the power cord provided into the back of the unit and then to
a properly grounded outlet. Use only the power cord provided.
3. Powering On
Turn heater power ON using the switch on the front of the unit.