SciGene 400 Hybridization Incubator - Manual (Page 9)

Model 400 Hybridization Incubator — USER MANUAL
Version 2.1, February 2011 (408) 733-7337, [email protected] 8
G. Loading and Removing Rotators
All rotators are loaded and removed using the same two-step process.
When loading, first insert the end of the shaft that ends in a ball joint
with alignment pin into the slotted bearing on the
right
wall of the
chamber. The left end of the shaft is then placed into the bearing on the
left side of the chamber. Reverse this procedure when removing the
rotator.
Insert shaft ball with alignment
pin into right bearing
Place end of shaft on left bearing