Sensaphone IMS-4000 Upgrade instructions - Manual (Page 10)

10 IMS-4000 Software Update Notice IMS-4000 Software Update Notice
Version 2.46 (February 21, 2003)
• Added SNMP agent for remote management via third party software.
• Implemented Alarm on Return-to-Normal feature for IP Alarms.
• Corrected issue regarding order of alarm delivery when multiple alarms are being processed.
• Corrected issue which caused Listen-in time to be cut short.
• Corrected issue regarding the displayed/spoken alarm limit on faxes, alphanumeric pages, and voice
calls if the limit changes while the alarm is being delivered.
• Corrected EventLog messages for e-mail feature.
• Corrected issue when reprogramming flash memory in several Nodes.
Version 2.41 (September 20, 2002)
• Added the ability to acknowledge alarms via the IMS Web Page.
• Added support for evaluation mode.
• Added support for the IMS 4–20mA Bridge.
(Requires input board firmware chip version 1.03 or greater)
• Improved timing accuracy for Alarm Reset Time
Version 2.40 (August 23, 2002)
• Resolved modem dialing and answering reliability issues.
Version 2.38 (July 25, 2002)
• System saves Last Alarm and Last Acknowledge times—even after system powerdown.
• Added support for Metropager.
Version 2.36 (June 28, 2002)
• Added PowerGate2 support.
• Resolved issue when using special characters in the Local password.
• Added Alarm on Return-to-Normal feature for environmental inputs.
Version 0.34 (June 5, 2002)
• Changed phrasing of IP alarms when an IP device has never responded.
• Removed Node status messages from voice report when Node is in trouble.
• WebFTP feature operational.
• Added support for Axis 2400 camera server.
Version 0.30 (May 17, 2002)
• Added PowerGate trouble alarm support
• Added support for programmable rings until answer feature.
• Changed two-way email message format. It now uses an email address instead of the Username.
• Resolved issue communicating with Nodes installed behind routers supporting NAT.
• Resolved issue saving input programming when loaded from a template.
Version 0.29 (May 10, 2002)
• Resolved issue in schedules for environmental inputs.
• Changed voice reports to say “Normal” instead of “OK” when reporting status.
Version 0.26 (April 30, 2002)
• Added option to skip dialtone detection when making a telephone call.
• Resolved voice menu issue when more than 1 PowerGate was configured.