Sensaphone IMS-4000 Upgrade instructions - Manual (Page 15)

IMS-4000 Software Update Notice
15
Version 2.05.31.0 (May 31, 2002)
• Removed ethernet error messages that appear during Local Configuration when network cable is not
connected.
• Added PowerGate2 support.
• Added support for PowerGate trouble alarm.
Version 2.05.08.1 (May 8,2002)
• Resolved issue when a Node alarm exists and the host reboots and no acknowledgement is
received.
• Resolved issue displaying dot quad addresses through local serial port.
Version 2.04.30 (April 30,2002)
• Modified internal file system.
• Made internal improvements in alarm logic processing.
• Made internal timing improvements.
2010 Models
Version 1.49 (January 26, 2012)
• Corrected problem which caused sensor recognition times to double.
Version 1.46 (June 10, 2011)
• Corrected problem prohibiting sensor trouble (disconnected) alarms from being dispatched.
Version 1.45 (March 22, 2011)
• Corrected problem which caused certain sensors to be incorrectly identified.
Version 1.44 (February 18, 2011)
• Added Ethernet Mode options in the Network Configuration menu for better compatibility with
legacy hubs and switches.
• Fixed a problem that could potentially cause the device to reboot unexpectedly.
Version 1.41 (January 12, 2011)
• Fixed a problem which caused the min/max values to be reversed for temperature sensors.
Version 1.39 (July 19, 2010)
• Fixed a problem which caused node sensors to load template defaults whenever the node and host
lost their connection or if either device rebooted.
• Fixed a problem with IP alarm pinging which would potentially cause IP alarm processing to stop.
• Fixed a problem which would sometimes cause firmware updates to fail when using ConsoleView.
In this case firmware updates must be done using the node web page (i.e. browse to the node IP
address and click Administration Options).
• Fixed the alarm status for a smoke detector.