Sensaphone IMS-4000 Upgrade instructions - Manual (Page 2)

2 IMS-4000 Software Update Notice
IMS-4000 ConsoleView Feature and Correction Summary
ConsoleView
Version 3.0.31 (April 10, 2013)
• Added optional Auto-Reconnect feature - reconnects to Host after 10 seconds following an
unexpected disconnect. Will continue to retry until a connection is established.
Version 3.0.30 (June 7, 2012)
• Increased the width of the Dependency IP drop down box on the IP Alarm properties screen.
• Added support for a new time zone variable to correctly show the IMS Host time when the Host and
PC are in different time zones.
Version 3.0.29 (January 26, 2012)
• Removed snmp 161, snmp-trap 162, and irc 194 from IP Alarm port list.
Version 3.0.28 (August 5, 2011)
• Updated software installation with additional files to support Axis cameras.
Version 3.0.26 (March 22, 2011)
• Upgraded the Axis camera control to support the latest versions of Axis cameras.
Version 3.0.25 (February 14, 2011)
• Added support for Axis camera server model 240Q
• Fixed problem which caused a software error when using certain model Panasonic cameras.
• Added two new modes for PowerGate Alarm Response which will initiate an outlet On or Off
response when the alarm occurs and reverse the action when the alarm returns to normal.
• Corrected an issue which would cause PowerGate event messages to be displayed on History
queries of environmental channels.
• Corrected the firmware and OS version display on the Node Diagnostic screen.
Version 3.0.23 (July 19, 2010)
• Corrected a problem which sometimes caused an error to occur when connecting to a host for the
first time.
• Enhanced the node diagnostic screen to refresh the version information more frequently.
Version 3.0.22 (April 23, 2010)
• Added support for IMS-4816 External Temperature Probe
• Improved Wireless Node programming and diagnostic screens
• Fixed an issue which caused the strip chart to generate an error when operating on 64-bit operating
systems
Version 3.0.20 (December 4, 2009)
• Added support for the IMS-4200 Wireless Node & Wireless Sensors
• Updated Software to install on Windows 64-bit Operating Systems
• Fixed a template programming error with regard to Reset Time. When enabled the Reset Time
would always be set to 30 minutes.
Version 3.0.18 (April 17, 2009)
• Added support for the IMS-4310 Dual Relay Output Module
Version 3.0.17 (October 15, 2008)
• Restored the Table High and Low programming fields when using the 4-20mA Bridge with a
custom table.