Summit DW2432SS Installation Manual - Manual (Page 12)

6.5 PREPARING THE WATER CONNECTION (A)
Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder
connections must be made before the water line is connected to the dishwasher’s water inlet
valve. Water can also be supplied to the dishwasher by using a flexible braided hose line.
Check with your plumbing supply sources for the proper hose and 90º elbow and necessary
fittings for the water supply line. This material is not supplied, and must be purchased separately.
WARNING
Installation should be performed by a qualified installer. Work by unqualified persons
could be dangerous and may void the warranty.
If the dishwasher is installed in a location that experiences freezing temperatures (e.g., in
a vacation home, cabin, etc.), you must drain all the water from the dishwasher’s interior.
Water system ruptures that occur as a result of freezing are not covered by warranty.
6.5.1 INSTALLING THE 90º ELBOW FITTING (B)
CAUTION
Do not tighten the 90º elbow. Doing so may
damage the water inlet valve and cause a water
leak
.
If the water supply line is to be copper tubing,
make certain that the elbow has a compression
fitting. Apply Teflon tape or other pipe sealant
when required. Orient the water supply connection
downwards as shown in the figure so the water line
can be easily pulled underneath or on the side of
the dishwasher.
6.5.2 JUNCTION BOX PREPARATION (C)
Remove the junction box cover by removing
the screws as shown in the figure. They will be
reinstalled later.
10