Summit DW2432SS Installation Manual - Manual (Page 17)

Install a strain relief (not supplied) into the
opening on the kick plate. (Figure A)
Pass the electrical supply cable through the
strain relief; make sure the strain relief clamps
the insulated outer casing of your electrical
supply cord and not the wires themselves.
Leave 2-15/16” to 3-15/16” (75mm / 100mm) of
insulated wire extending through the strain relief
(Figure B). Tighten the strain relief screws.
(Make sure you cannot pull the electrical cord
out of the strain relief.)
Do not pre-twist the wires before connecting
them with wire nuts.
Using the supplied wire nuts, connect the
electrical supply wires to the dishwasher’s wires,
black to black, white to white, and green or bare
to green or bare. Make certain that the insulated
wires show no bare wire from the bottoms of the
wire nuts. Gently tug the wires to make certain
they are securely connected (Figure C).
7.2.2 FASTEN JUNCTION BOX
1. Pull the wires into the junction box. Be sure
that the wire nuts do not loosen.
2. Replace the cover on the junction box.
3. Secure the cover with the screws (Figure D).
15