Summit DW2432SS Installation Manual - Manual (Page 13)

6.6 DRAIN PREPARATION
The dishwasher drain hose may be connected to the drain plumbing in one of three ways
(Figures A, B, C).
Notice:
 Use any one of these methods. Otherwise, the dishwasher will not operate properly.
 A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected and the
hole plugged.
 The total length of the drain hose is 76¾” (1950mm). If a hose extension is required, a
drainage hose of equal quality must be used.
 The maximum length must not exceed 157½” (4000mm). Otherwise, the cleaning process is
negatively influenced.
6.6.1 UNDER THE SINK DRAIN
Install a Y-branch tail pipe. (Figure A)
Notice:
 You must add a loop at least 28” (710mm) above the floor of
the cabinet and above the drain connection in the drain hose to
prevent waste water from not draining properly, and causing
either poor washing results or a bad odor.
6.6.2 INSTALLING AN AIR GAP
If the local ordinance requires an air gap (Figure B).
Notice:
 Check with local ordinance for type of air gap required.
6.6.3 DISPOSAL
Remove the drain connection plug before attaching the drain hose from
the dishwasher.
Every disposal has a hookup for a dishwasher. Consult your disposer
manual for correct connection. (Figure C)
11