Summit DW2432SS Installation Manual - Manual (Page 19)

Lock the toe kick brackets as shown with the plastic
tab in Figure C by pushing the plastic tab on the
dishwasher into the teeth of the bracket (C).
3. Now attach the toe kick to the bracket with the two
(  3/16” x 1/4” ‒  4mm x 6mm) screws and the
caps provided as shown.
If the enclosure height is below 33-1/16” (840mm),
use only “o” labeled toe kick (toe kick without slots).
Installation should be done following the steps
illustrated in Figures A, B and C respectively.
1. Bend tabs on toe kick (o) inwards (A).
2. Secure toe kick to brackets with screws (t) as
shown in the supply bags (B).
3. Attach caps (s) as shown in the supply bags (C).
If the enclosure height is above 33-1/16” (840mm),
use “o” and “p” labeled toe kicks together. Make
sure the slotted toe kick “p” is on the outside so you
can adjust height of the toe kick. Installation should
be done following the steps illustrated in the figures
A
, B and C respectively.
1. Align the toe kick (o) and (p) (A).
2. Secure toe kicks to brackets with screws (t) after
adjusting the height of the slotted toe kick (p) (B).
3. Attach caps (s) as shown in the supply bags (C).
If the enclosure height is above 34¼” (870mm), use
“o” and “r” labeled toe kicks together. Make sure the
slotted toe kick “r” is on the outside so you can
adjust height of the toe kick. Installation should be
done following the steps illustrated in the figures A,
B
and C respectively.
1. Align the toe kick (o) and (r) (A).
2. Secure toe kicks to brackets with screws (t) after
adjusting the height of the slotted toe kick (r) (B).
3. Attach caps (s) as shown in the supply bags (C).
17