TCI HGP - Manual (Page 22)

C P K I T O P T I O N ( 0 )
CP KIT OPTION (0) HGP IOM Manual 22
CP Kit Enclosure (8) with Option (0)
The HGP CP Kit Option is a harmonic filter component package designed and developed by TCI to
allow qualified customers to build harmonic filters to reduce the harmonic currents drawn from the
power source by VFDs. The HGP CP Option is available for 480 volt systems (60 Hz). When properly
designed, assembled, and installed, the completed product is intended to be suitable for use with
3-phase diode bridge rectifier loads such as PWM AC VFDs. SCR or thyristor loads such as DC drives
would require a different filter configuration outside the scope of this product offering. Please contact
TCI Technical Support for additional information.
Product Description
HGP CP Kit Option Filter
The HGP CP Kit Option is a package of the primary passive filter components needed to build and
install a harmonic filter on a VFD or VFD system. The filter components are tuned to provide a low
impedance path for the major harmonic currents demanded by the VFD when following the schematic
connections used by TCI in the HGP filter.
The HGP CP Option filter component package consists of the following components:
♦ A KDR tuned series reactor.
♦ A TCI 3-phase tuning reactor specifically designed for the HGP filter.
♦ High-endurance, harmonic-rated capacitors.
♦ Bleeder resistors to ensure safe capacitor discharge upon filter shutdown, located on
capacitors.
♦ Fasten terminals for wiring single-phase capacitors (select models